Setting The System; When The System Is Set; Activating The System - Toyota 2007 Tundra Owner's Manual

07 04.26
XS12001
Indicator light
XS12027a
Glass breakage sensor (on some models)
40

SETTING THE SYSTEM

1. Turn the ignition key to the "LOCK"
position and remove it.
The indicator light will start flashing when
the key is removed from the ignition
switch. (See "Engine immobilizer system"
on page 21 in this Section for details.)
2. Have all passengers get out of the
vehicle.
3. Close and lock all the doors and hood.
The indicator light will remain on when all
the doors and hood are closed
locked.
The system will automatically be set after
30 seconds. When the system is set, the
indicator light will start flashing again.
4. After making sure the indicator light
starts flashing, you may leave the ve-
hicle.
Never leave anyone in the vehicle when
you set the system, because unlocking
from the inside will activate the system.
2007 TUNDRA from Jul. '07 Prod. (OM34463U)

WHEN THE SYSTEM IS SET

Activating the system

The system will sound the alarm under
the following conditions:
D
If any of the doors is unlocked or
opened without the key or wireless re-
mote control transmitter, or if the hood
is forcibly opened
D
If the battery terminal is disconnected
and then reconnected
Vehicles with the glass breakage sensor—
and
D
The side windows are tapped or bro-
ken.
The indicator light will come on when the
system is activated.
If the alarm has been activated and the
key is not in the ignition switch, all the
doors will re−lock automatically.
After one minute, the alarm will automati-
cally stop and the indicator light will start
flashing again.