Toyota 2007 Tundra Owner's Manual page 581

07 04.26
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
The side turn signal lights consist of a
number of LEDs. If any of the LEDs burn
out, take your vehicle to your Toyota deal-
er to have the light replaced.
CAUTION
D
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
D
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
564
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
if
Light bulbs
Headlights
(high beam)
Headlights
like the
(low beam)
Front fog lights
Parking and front
side marker lights
contact your
Front turn
signal/parking
lights
Rear turn signal
lights
Stop/tail and rear
side marker lights
Back−up lights
License plate
lights
High mounted
stoplight and
cargo lamps
Interior lights
2007 TUNDRA from Jul. '07 Prod. (OM34463U)
Bulb
W Type
No.
9005 65 A
— 55 B
9145 45 C
168 5 D
4157
27/8 E
NAK
3157A 27/8 E
3157 27/8 D
921 18 D
168 4.9 D
921 18 D
— 5 D