Service Connector For Towing Brake Controller; Tires - Toyota 2007 Tundra Owner's Manual

07 04.26
Connector
cover
XS30014a
Trim board
Scuff
plate
Clip
486
SERVICE CONNECTOR FOR TOWING
BRAKE CONTROLLER (with
package)
Your vehicle is equipped with a service
connector for the trailer brake controller
as shown.
Access the service connector.
1. Remove the scuff plate.
2. Remove the clip (screw type) and trim
board.
Remove the connector cover from the ser-
vice connector before connecting the con-
nector.
Link the connector to the trailer brake
controller via the sub wire harness stored
in the glove box. The detailed explanation
of the sub wire harness circuit is packed
together with the sub wire harness.
Be sure to position the trailer brake con-
troller where it does not prevent the driver
from operating the pedal.
Toyota recommends that the sub wire har-
ness be stored in the glove box when it
is not in use.
2007 TUNDRA from Jul. '07 Prod. (OM34463U)

TIRES

towing
D
Ensure that your vehicle's tires are
properly inflated. See page 548 in Sec-
tion 7−2 and page 586 in Section 8 for
instructions.
D
The trailer tires should be inflated to
the pressure recommended by the trail-
er manufacturer in respect to the gross
trailer weight.