07 04.26
Side chain
G72017
Cross chain
TIRE CHAIN SELECTION
Use the tire chains of correct size.
Use the following type chains.
A Diameter of side chain:
5.0 (0.20)
B Diameter of cross chain:
6.3 (0.25)
Regulations regarding the use of tire
chains vary according to location or
type of road, so always check local reg-
ulations before installing chains.
NOTICE
If the wrong combination of tire and
chain is used, the chains could dam-
age the vehicle body.
CHAIN INSTALLATION
Install the chains on the rear tires as
tightly as possible. Do not use tire
chains on the front tires. Retighten
chains
after
driving
(1/4—1/2 miles).
When installing chains on your tires, care-
fully follow the instructions of the chain
manufacturer.
If wheel covers are used, they will be
scratched by the chain band, so remove
the covers before putting on the chains.
mm (in.)
D
Do not exceed 50 km/h (30 mph) or
the
chain
0.5—1.0
km
mended speed limit, whichever is
lower.
D
Drive
carefully
holes, and sharp turns, which may
cause the vehicle to bounce.
D
Avoid sharp turns or locked−wheel
braking, as use of chains may ad-
versely affect vehicle handling.
D
When driving with chains installed,
be sure to drive carefully. Slow
down
before
avoid losing control of the vehicle.
Otherwise an accident may occur.
Snow tires or chains may affect the
tire pressure warning system.
"Tire pressure warning system" on
page 251 in Section 1−7.
2007 TUNDRA from Jul. '07 Prod. (OM34463U)
CAUTION
manufacturer's
recom-
avoiding
bumps,
entering
curves
to
NOTICE
See
555