Towing Connector For Trailer Lights; Break−In Schedule; Maintenance - Toyota 2007 Tundra Owner's Manual

07 04.26
XS30005
4−Pin connector
XS30006
4−Pin, 7−Pin connector
TOWING CONNECTOR FOR TRAILER
LIGHTS
D
Your vehicle is equipped with wire har-
ness sockets for trailer lights under the
rear bumper. Use them to connect and
operate the trailer lights. However, the
trailer lights must comply with federal,
state/provincial and local regulations.
See your local recreational
dealer or rental agency for the correct
type of wiring and relays for your trail-
er. Check for correct operation of the
turn signals and stop lights each time
you hitch up. Direct splicing may dam-
age your vehicle's electrical system
and cause a malfunction of your lights.
The towing connector can be also con-
nected to the trailer brake and trailer
sub battery.
2007 TUNDRA from Jul. '07 Prod. (OM34463U)
BREAK−IN SCHEDULE
D
If your vehicle is new or equipped with
any new power train components (such
as the engine, transmission, differential
and wheel bearing),
mends that you do not tow a trailer
until it has been driven for over 800
km (500 miles). After the vehicle has
vehicle been driven for over 800 km (500
miles), you can start towing. However,
drive the vehicle at a speed of less
than 80 km/h (50 mph) when towing a
trailer for another 800 km (500 miles).
In addition, avoid full throttle accelera-
tion.

MAINTENANCE

D
If you tow a trailer, your vehicle will
require more frequent maintenance due
to the additional
information, please
scheduled maintenance information in
the "Scheduled Maintenance Guide" or
"Owner's Manual Supplement".
D
Retighten all fixing bolts of the towing
ball and bracket after approximately
1000 km (600 miles) of trailer driving.
Toyota recom-
load. For this
refer to the
487