Zoom Display Of Odometer And Trip Meter; Average Fuel Consumption; Instantaneous Fuel Consumption; Driving Range - Toyota 2007 Tundra Owner's Manual

07 04.26
1. Zoom display of odometer and trip
meter
The odometer and one of the trip meters
are displayed simultaneously.
"—Odometer and two trip meters".

2. Average fuel consumption

("Average Fuel Economy")
Average fuel consumption is calculated
and displayed based on total driving
distance and total fuel consumption
with the engine running.
The displayed value is updated every 10
seconds.
To reset the calculations, push and hold
the "SELECT RESET" button for more
than 2 seconds.

3. Instantaneous fuel consumption

("Current Fuel Economy")
The instantaneous fuel consumption is
calculated and displayed based on dis-
tance and fuel consumption at 20 revo-
lutions of the engine.
The displayed value is updated for a short
time.
An accurate figure may not be shown if
the vehicle is driving down a long slope,
and engine brake is applied. (The display
will indicate the extremely low fuel con-
sumption.)
The display indicates 0 when the vehicle
is stopped with the engine running.
The calculation is reset when the ignition
See switch is turned off.
4. Driving range ("Distance To Empty")
The distance the vehicle can travel with
the remaining fuel is calculated and
displayed based on the quantity of re-
maining fuel and past fuel consumption.
The driving range display indicates the
approximate distance that you can drive
until the fuel gauge reaches "E". It is
different from the actual distance traveled.
The displayed value is updated every time
the fuel equivalent for 1 mile or 1 km is
consumed.
Every time you refuel the vehicle, the cal-
culation is reset. However, when only a
small amount of fuel is added to the tank,
the display may not be reset.
The actual driving range varies with driv-
ing habits and road conditions. If fuel con-
sumption is good, the driving range will be
longer than indicated. If fuel consumption
is poor, the driving range will be shorter
than indicated.
If the low fuel level warning light comes
on, refuel the vehicle even if the display
indicates that the vehicle can be driven
further.
5. Driving time ("Trip Timer")
To calculate the driving time, display
the "Trip Timer" after the engine has
been started. Then press the "SELECT
RESET" button. To stop the calculation,
press the "SELECT
again.
Driving time is counted from 00:00:00. Up
to 99:59:59 (99 hours, 59 minutes and 59
seconds) can be displayed. When the driv-
ing time exceeds 99:59:59, the counter
returns to 00:00:00.
If the ignition switch is turned off while
the driving time is being calculated, the
calculation will cease. When the engine is
next started, it will automatically resume
from the previous value.
If the "SELECT RESET" button is pressed
to cease the calculation and then the igni-
tion switch is turned off, the calculation
will not resume when the engine is next
started. In this case, press the "SELECT
RESET" button to start the calculation.
To reset the calculation, push and hold
the "SELECT RESET" button for more
than 2 seconds.
2007 TUNDRA from Jul. '07 Prod. (OM34463U)
RESET" button
189