Checking The Engine Oil Level - Toyota 2007 Tundra Owner's Manual

Hide thumbs Also See for 2007 Tundra:

Table of Contents

Checking the engine oil level

4.0 L V6 (1GR−FE) engine

4.7 L V8 (2UZ−FE) engine

5.7 L V8 (3UR−FE) engine

With the engine at operating tempera-

ture and turned off, check the oil level

on the dipstick.

1. To get a correct reading, the vehicle

should be on level ground. After turning

off the engine, wait a few minutes for

the oil to drain back into the bottom of

2. Pull the dipstick out, hold a rag under

the end and wipe it clean.

3. Reinsert the dipstick—push it in as far

as it will go, or the reading will not be

2007 TUNDRA from Jul. '07 Prod. (OM34463U)

4. Pull the dipstick out and look at the oil

level while holding a rag under the

Be careful not to touch the hot ex-

haust manifold.

Be careful not to drop engine oil on

the vehicle components.

If the oil level is below or only slightly

above the low level, add engine oil of

the same type as already in the engine.

Remove the oil filler cap and add engine

oil in small quantities at a time, checking

the dipstick. We recommend that you use

a funnel when adding oil.

The approximate quantity of oil needed to

raise the level between low and full on the

dipstick is indicated as follows:

1.5 L (1.6 qt., 1.3 Imp.qt.)

Show Quick Links

Table of Contents