Add Inads Phone Numbers; Enable Alarms To Inads Via Modem - Avaya S8700 Installing Manual

228 Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Completing the Installation Administration
You must assign a product ID number to the configuration. You can obtain this product ID
number from the Automatic Registration Tool (ART) script or your Avaya Business Partner
representative.
1 Click Start > Run to open the Run dialog box
2 Type telnet 192.11.13.6 and press
Log in as craft or dadmin (if business partner).
3
4 At the prompt type

Add INADS phone numbers

NOTE:
Do these steps only if the customer has a maintenance contract with Avaya.
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
1 Click Start > Run to open the Run dialog box
2 Type telnet 192.11.13.6 and press
Log in as craft or dadmin (if business partner).
3
4 At the prompt type almcall -f 9,18005353573 (if a direct line, you do not need the 9,)
If alarms will be reported to a second number type almcall -s second-number and press
5
Enter
At the prompt type almcall and press
6
entered.

Enable alarms to INADS via modem

NOTE:
Do these steps only if the customer has a maintenance contract with Avaya.
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
Click Start > Run to open the Run dialog box
1
2 Type telnet 192.11.13.6 and press
Log in as craft or dadmin (if business partner).
3
At the prompt type
4
5 Type
Log off.
6
productid -p
.
almenable -d b and press
almenable and press
Enter
May 2003
.
Enter
and press
number
Enter
.
Enter
. Verify that the proper information has been
Enter
.
Enter
.
Enter
to verify that the alarms are enabled.
.