Using A Kim As A Central Answer Position - Nortel ICS 6.1 Manual

Monitoring telephones with the CAP module
The indicators beside internal autodial buttons on your CAP module
show the status of Norstar telephones.
The indicator is on when the telephone has:
• an active call
• Do Not Disturb turned on
The indicator is off when a telephone has:
• no active call
• a call on hold and no other active call
Tip -

Using a KIM as a central answer position

When you deploy a CAP consisting of a T7316E telephone and one or
more KIMs, the modules can be configured as eKIMs by your installer. If
you do not need lines or hunt group appearances on the KIMs, there is no
requirement for any system configuration. This configuration of the KIM
is called an ordinary KIM (OKIM) and you can install up to nine modules
on a T7316.
Note: You must have version 6.1 or newer software to program this type
of CAP.
It is best if the CAP is the prime telephone and direct-dial telephone for the
lines and telephones it serves.
P0603544 02
You can send up to 30 messages from a CAP.
Answering calls / 49
Compact ICS 6.1 System Coordinator Guide