Changing A User Speed Dial - Nortel ICS 6.1 Manual

Used when you are setting up an external autodial number. Press
to use.
Press to store a feature code on the button.
Locates a specific button on a telephone by entering its number.
Button numbers are shown in the illustrations.
Takes you to a list of feature codes. Press
through the list and press
program on the button.
Information about individual displays you may see is described at the end
of this section.

Changing a User Speed Dial

1. Press
of speed dial codes that are available.
2. Press
3. Press
4. Press
5. Press
would dial it on the telephone.
6. Press
7. Press
the speed dial code should use.
Use the line pool code to select a particular line pool for use with Speed
Dial. If you select
programming according to the initial digits in the number.
The route you choose for a User Speed Dial code must be one that the
telephone can use. For example, if the telephone does not have access to
Line Pool B and you use that pool code with the speed dial code, the code
does not work. Lines and line pools are assigned to the telephones by the
system administrator. Refer to the Compact ICS 6.1 Installer Guide for
details.
To change a system speed dial code, see ''Adding or changing a system
speed dial'' on page 31.
P0603544 02
until you see the type of line or pool you want the number
at
to see the first speed dial code (256).
to move through all the speed dial codes.
at the code you want to change.
and enter the telephone number the same way you
.
and choose the line (or enter a code for a line pool)
User Preferences / 167
when you see the feature you want to
. The display shows the number
, a line or pool is chosen by the routing
Compact ICS 6.1 System Coordinator Guide
to move