Pitney Bowes DP50S Hardware Manual page 68

5. Paper and Other Media
Coated paper setup
5
Additional cautions
Special paper
Special paper standard
Printer setup
Printer driver setup
Supported paper feeding tray
Paper capacity
Duplex printing
66
Default: [Coated Paper 1]
If the print quality needs to be improved, select
[Maintenance] [General Settings]
[Coated Paper Setting]
to [Coated Paper 7].
When selecting the paper settings depend-
ing on the thickness, select [Coated Paper 1]
to [Coated Paper 5]. High numbered settings
allow thicker paper to be used, but are printed
more slowly.
When selecting the paper setting depending
on the type, select [Coated Paper 6], [Coated
Paper 7].
High numbered settings allow thicker paper to
be used, but are printed more slowly.
• Print speed is slightly slower than when
using plain paper
• Fan the paper before loading it. When using
the bypass tray, set the paper one page at
a time if multiple sheets are fed, paper jams
occur, or you hear a strange noise.
When you can not print successfully with other paper
type setting, set special paper.
Select [Paper Input] [Paper Type: (tray name)]
[Special Paper 1] to [Special Paper 3].
Select [Special 1] to [Special 3] in [Paper type].
Any input tray can be used.
Make sure paper is not stacked higher than the upper
limit mark ( ) inside the tray. When using the bypass
tray, make sure paper is not stacked higher than the
paper guides inside it.
Supported
[Coated Paper 1]