Pitney Bowes DP50S Hardware Manual page 145

The same IP Address exists on several interfaces (###)
The same IP address has already been set on several interfaces. Contact the network administrator.
The same IPv4 Address already exists.(102/202)
The IPv4 address specified for the machine is already in use by another device on the network.
Contact the network administrator.
The selected job(s) has already been printed or deleted.
This message might appear if you print or delete a job from Web Image Monitor. Press Exit on the
message screen.
This NetBIOS name is already in use.(108/208)
The NetBIOS name specified for the machine is already in use by another device on the network.
Contact your network administrator.
Toner is almost empty.
The printer is almost out of the toner indicated in the message. Contact your sales or service repre-
sentative to obtain a new unit.
(tray name) Error. Power Off/On. Error recurs, call service.
There was an error with an input tray motor. Turn the power off, and then on again.
Turn power off, then set the PCU correctly.
The black drum unit/color drum units are not set correctly. Turn the power off, and then set the black
drum unit/color drum units again.
USB has a problem. Please call service.
The printer has detected a USB board failure. Turn the power off, and then on again. If the problem
persists, contact your sales or service representative.
Values set for IPv6/Gateway addresses are invalid.(110/210)
The IPv6 address or gateway address is invalid. Check the network settings.
Waste Toner almost full Contact your local vendor. Please call service.
The waste toner bottle is almost full. Contact your sales or service representative.
Waste Toner Bottle full
Replace the waste toner bottle. See p.156 "Replacing the Waste Toner Bottle".
WPA Auth. incomplete.(211)
WPA authentication could not complete. Contact your network administrator.
Error and Status Messages that Appear on the Control Panel
9
143