Pitney Bowes DP50S Hardware Manual page 37

8. Carefully insert the Gigabit Ethernet board vertically, all the way to the back.
Push the Gigabit Ethernet board all the way to the back, and confirm that it is securely con-
nected to the controller board.
9. Use 2 coin screws to fasten the Gigabit Ethernet board to the controller board panel.
10. Fit the controller board into the printer, and push it carefully until it stops.
Push it firmly into the printer using the handle. The printer may malfunction if the controller
board is not properly installed.
BMV163S
BMV164S
BMV286S
Installing the Interface Units
2
35