Pitney Bowes DP50S Hardware Manual page 38

2. Installing Options
11. Fasten the controller board to the printer using the five screws.
2
• Confirm that the board was correctly installed by printing the configuration page. If it is correctly
installed, "Gigabit Ethernet Board" will appear for "Device Connection" on the configuration page.
• If the board was not installed properly, repeat the procedure from the beginning. If it cannot be
installed correctly even after reattempting installation, contact your sales or service representative.
• For information on printing the configuration page, see "List/Test Print Menu", Software Guide.
• Before using the board, you must configure settings from the control panel. For details, see "Ethernet
Configuration".
• "Ethernet Cable Connection"
• "Ethernet Configuration"
36
BMV271S