Pitney Bowes DP50S Hardware Manual page 65

OHP transparencies
Printer setup
Printer driver setup
Supported paper feeding tray
Paper capacity
Duplex Printing
Additional Cautions
Letterhead
Printer setup
Printer driver setup
Supported paper feeding tray
Paper capacity
Select [Paper Input] [Paper Type: Bypass
Tray] [OHP (Transparency)].
Select [OHP Transparency] in [Paper Type].
Bypass tray
Make sure paper is not stacked higher than the
paper guides inside the bypass tray.
Not supported
• When loading OHP transparencies, take care not to
load them upside down. Doing so may cause
malfunction.
• It is recommended to place one sheet at a time.
• Make sure to fan OHP transparencies every time
before printing. Leaving OHP transparencies loaded
in the paper tray may cause them to stick together and
result in a misfeed.
• If multiple OHP transparencies are fed at the same
time, load them one by one.
• When printing on OHP transparencies, remove the
transparencies one by one as they are output.
Select [Paper Input] [Paper Type: (tray name)]
[Letterhead].
Select [Letterhead] in [Paper type].
Any input tray can be used.
Make sure paper is not stacked higher than the upper
limit mark ( ) inside the tray. When using the bypass
tray, make sure paper is not stacked higher than the
paper guides inside it.
Paper Recommendations
5
63