Pitney Bowes DP50S Hardware Manual page 64

5. Paper and Other Media
Duplex Printing
Additional cautions
5
Thin paper
Paper Thickness
Paper setup
Paper driver setup
Supported paper feeding tray
Paper capacity
Duplex Printing
Additional Cautions
62
• [Thick Paper 1]: Supported
• [Thick Paper 2], [Thick Paper 3]: Not supported
• Print speed is slightly slower than when using plain paper.
• When loading paper in the printer paper trays or the paper
feed units, load at least 20 sheets. Also, adjust the side
guide so that it lightly touches the paper.
• Curled paper: If the paper is curled, flatten the paper before
loading it.
• If you are using thick paper with a smooth surface, paper
jams or multiple feeding can occur. Fan the paper before
loading it. If a paper jam or multiple feeding occurs even
after you have fanned the paper, set the paper one sheet at
a time.
52 to 59 g/m² (14 to 16 lb.)
Select [Paper Input]
Tray] [Thin Paper].
Select [Thin (52 - 60 g/m²0] in [Paper type].
Bypass tray
Make sure paper is not stacked higher than the
upper limit mark (
the bypass tray, make sure paper is not stacked
higher then the paper guides inside it.
Not supported
When printing on thin paper, make a test print
and check the print quality. Depending on the
type of paper you are using, print quality may
degrade.
[Paper Type: Bypass
) inside the tray. When using