Pitney Bowes DP50S Hardware Manual page 51

5. Press the [ ] or [ ] key to select the appropriate network protocol, and then press the [OK] key.
6. Press the [ ] or [ ] key to select [Active] or [Inactive], and then press the [OK] key.
Set other protocols you need to set in the same way.
• Select [Inactive] for unused protocols.
• Enable IPv4 to use the pure IPv4 environment of NetWare5/5.1, Netware 6/6.5. 7. Press
the [Escape] key until the screen returns to the [Network] menu.
8. If you use IPv4, assign the IPv4 address to the printer. Press the [ ] or [ ] key to select [Machine IPv4 Ad-
dress], and then press the [OK] key.
To get the IP address for the printer, contact your network administrator.
9. To specify the IP address, press [IP Add.].
If you use IPv4, also assign the subnet mask and gateway address. To assign these, press [Sub-
net M] or [Gateway].
10. Press the [ ] or [ ] to enter the address, and then press the [OK] key.
Press the [ ] or [
field, press the [ ] key, and then you can enter the next field. After completing entry of the all
fields, press the [OK] key. Use the same method to assign the subnet mask and gateway ad-
dress.
] key to enter the left-most entry field of the address. After entering the left
Ethernet Configuration
4
49