System Reset Options (Address 4091-4093); User Program Mode; Preliminary Information - NAPCO GEMINI GEM-P3200 Programming Instructions Manual

Page 52
SYST EM RES ET OPT ION S (A DDR ESS 40 9 1-40 93 )
4091 XX
GEM-RP1CAe2/GEM-K1CA Keypad
GEM-RP2ASe2 Keypad
4093 XX
GEM-RP1CAe2/GEM-K1CA Keypad
GEM-RP2ASe2 Keypad

USER PROGRAM MODE

PRELIMINARY INFORMATION

The User Program Mode is covered in detail in the operating instructions for the keypad in use.
Only Keypad #1 may be used for programming, however this keypad may be located in either area.
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-
up.
After entering codes or data, press the save
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
NOTE: For ease of programming, it is recommended that a GEM K1CA (or GEM-RP1CAe2) be used as Keypad #1. A new GEM-
K1CA and a new GEM-RP1CAe2 are automatically configured as Keypad #1. See Keypad Configuration Mode.
Press the C button to silence the sounder and exit the User Program Mode.
If a GEM-RP2ASe2/GEM-K2AS keypad is used, configure address jumpers as Keypad #1 (See WI1184).
X
GEM-P3200 Programming Instructions
Clear Dealer Program (Erases Dealer Program)
Access address 4091, then press the
4091XX
allowed.
NOTE: Enter Easy Menu Driven Program Mode to program system
again.
Cold Start (Erases Entire Program)
4093XX
Access address 4093, then press the
allowed.
NOTE: Some features (schedules, language configuration) can only be
re-programmed with the Downloading Software.
U
button. Data will not be stored into memory unless this button is pressed.
This erases the dealer program. Use this feature to start
a customized default program.
J
or
This erases the entire program (codes, schedules,
foreign language configuration, etc), leaving the panel
as it came right out of the box.
J
or
L
WI818G 10/05
U
button. Data entry is not
U
button. Data entry is not
NAPCO Security Systems