Cs Reporting Codes (Address 0870-0904); Cs Area & System Reporting Options (Address 1024-1027) - NAPCO GEMINI GEM-P3200 Programming Instructions Manual

WI818G 10/05
ADDRESS
SYSTEM REPORTING
0870-0880
CODES
LEFT ADDR
Test Timer
Alarm Supervisory
Bus Failure
Memory Failure
Low Battery
AC Failure
EZM Tamper
Sensor Watch
RESERVED
blank (•)
RESERVED
blank (•)
Telco Line Failure
CAUTION: For all 2-Digit Reporting Formats (see CS Receiver Format Options), use the following:
Example: The 2-digit reporting code as shown is "21".
CS AREA & SYS TEM R E POR TIN G OP TION S (ADD RESS 10 24 -102 7 )
CS Area Reporting Options
DISABLE OPENING REPORTS
DISABLE CLOSING REPORTS
CS System Report Options
1027
Option
Default
OFF 1
2
OFF
3
ON
OFF 4
OFF 5
OFF 6
OFF 7
OFF 8
L
NAPCO Security Systems
CS REPOR TIN G CODES (ADDRESS 0870-0904)
SYSTEM REPORTING
CODES
RIGHT
Digital Dialer Test
0870
RESERVED
0871
RESERVED
0872
Service Message
0873
Program Change
0874
RF Receiver Trouble
0875
RF Tamper
0876
RF Trouble
0877
0878 blank (•)
[Default = blank (•) blank (•) from address 0870-0904]
0879 blank (•)
0880
Reporting
2nd Digit of Reporting Code
ADDRESS
1024
1025
Backup Report on Telco 2
Touch-tone Dialing Only *
Touch-tone Dialing w/Rotary Backup *
Transmit "402" Opening/Closing Code
Cancel Next Test Timer on any Report
Disable Wait for Silence
Disable Wait for Handshake
Handshake for Local Telemetry
ADDRESS
0890-0897
LEFT ADDR RIGHT
0890
0891
0892
0893
0894
0895
0896
0897
ADDRESS Loc.
LEFT RIGHT
Code
1 2
1st Digit of Reporting Code
AREAS 1 2
A1 A2
1 2
CS AREA & SYSTEM REPORTING OPTIONS:
1. Select the desired option entering the
option number (1-8) for each digit.
2. Enter corresponding option number in
address location.
NOTE: Dark shaded data value box shows op-
tion not available.
U
3. Press
* NOTE: If neither TouchTone Dialing nor
TouchTone w/Rotary Backup is selected, then
system defaults automatically to Rotary Dialing.
Leave blank (•) to select Rotary Dialing.
X
KEYPAD REPORTING
CODES
LEFT
Ambush
Panic
Fire
Auxiliary
Tamper
CS SYSTEM REPORTING CODES:
1. Enter in corresponding address location
(left and right digits).
NOTE: Left digit is the first digit and right
digit is the second digit in a two digit CS
receiver format.
2. Valid entries are: 1-9, 0 and B-F.
NOTE: A is not permitted.
3. To disable a code leave boxes blank (•).
NOTE: Dark shaded data value box
shows option not available.
U D
4. Press or to save.
D
or to save.
GEM-P3200 Programming Instructions
Page 25
ADDRESS
0900-0904
ADDR RIGHT
0900
0901
0902
0903
0904