Zone Descriptions - NAPCO GEMINI GEM-P3200 Programming Instructions Manual

Page 54
ZONE DESCRIPTIONS (GEM-RP1CAE2 / GEM-K1CA KEYPADS)
01-
(Direct Entry)
PRESS: CHARACTERS DISPLAYED
IN SEQUENCE
[1]
ABC1
[2]
DEF2
[3]
GHI3
[4]
JKL4
[5]
MNO5
[6]
PQR6
[7]
STU7
[8]
VWX8
[9]
YZ90
[0]
(SPACE) - . ( ) , / : ? #
Press [ ] to move cursor right.
A
Press [ ] to move cursor left.
B
Notes:
1. After releasing the number button for 1 second, the character will be accepted and the cursor advanced to the
right.
2. After releasing the number button, if a new number button is pressed before the 1 second window expires, the cur-
rent character will be accepted and the cursor automatically advanced to the right. The first of the 4 characters of
this new number button will be displayed.
3. To erase an existing entry, use [
new character to overwrite the old.
4. To generate lowercase characters, the [
button. If the [
G
U
case. Press to save.
To proceed to the next description, place the cursor under the Zone Number (e.g. "1") and press the number that corre-
sponds to the zone. Repeat this procedure until all zones have been programmed. After programming the user codes,
press the NEXT button to proceed.
Enter Date
( / /
(Direct Entry)
Enter Time
( :
(Direct Entry)
NOTE: To enter the date and time, GEM-RP1CAe2/GEM-K1CA keypad (version 6 or greater) must be used and
"Enable Keypad Time/Date Display" (Address 3874) must be enabled.
X
GEM-P3200 Programming Instructions
Enter an identifying description for each zone. Characters are selected by
pressing keypad buttons multiple times, "Cell Phone" style. Buttons
through
9
HOLD G
AND PRESS:
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[0]
] or [
A B
] button must be pressed and held down while pressing the number
G
] button is released during the 1 second window, the current character will change to upper-
Enter Date (Press the (
Enter the current date in the format MM/DD/YY, where MM = the month
)
(01–12); DD=the day (01–31); and YY=the year. Press U to save. Press
NEXT button to proceed.
Enter Time (Press the (
Enter the current time in the format HH:MMA/P, where HH=hours (01–12);
)
MM=minutes (00–59). Select Am or Pm by pressing any number button,
then press
plus and are used, as per the following table:
0 G
CHARACTERS DISPLAYED
IN SEQUENCE
abc1
def2
ghi3
jkl4
mno5
pqr6
stu7
vwx8
yz9
0
(International Characters)
] to move the cursor below the character to be changed. Enter a
) button to set cursor.)
R
) button to set cursor.)
R
U
once again to save.
WI818G 10/05
L
NAPCO Security Systems
1