Programming Conventions Used In This Manual - NAPCO GEMINI GEM-P3200 Programming Instructions Manual

Page 18
PROGRAM THE DATA ENTRIES
1. Enter the panel's Dealer Security Code, then press
2. Answer NO to all questions until "ACTIVATE PROGRAM Y/N" is displayed; then press YES. NOTE: If you pass "ACTIVATE
PROGRAM", scroll backward using
3. Press to enter the Address Program Mode. Address "0000" will display.
C
4. Press
0900
vance to the data field.
5. Since you wish the reporting code to be "1B", press
G1 to enter a "B" in the display. NOTE: The right address is reported first, therefore, in the ad-
dress table, the right digit is the 1st digit of the reporting code ("1" in this example).
U
6. Press to save. Address 0900 is now programmed with an Ambush reporting code of "1B".
7. Press and enter another 4-digit address to continue programming--or--press
R
normal keypad operation.

PROGRAMMING CONVENTIONS USED IN THIS MANUAL

The Keypad Programming Worksheets that follow are provided as an address-programming reference to help the in-
staller modify his custom default program or to make minor field alterations to an existing panel program. It is recom-
mended that the panel be uploaded to NAPCO's PCD-Windows software following any keypad programming and that
the PCD-Windows's error-check feature be utilized to reduce the possibility of programming omissions or conflicts.
3
Keep the Keypad Programming Worksheets on file for future reference.
General Programming Steps
1. Contact the central station to ascertain receiver format, data format, event codes, subscriber numbers and tele-
phone number(s).
2. Select the desired features by writing in (pencil recommended) the respective "address" boxes. Refer to the
Programming Options and Worksheets for guidance in selecting the "data" to be entered into those boxes.
3. Program the data entered in the boxes on the worksheets into the respective addresses. The display will show
the entry numerically, but if hexadecimal format will display "0" for the number 10, and letters "B", "C", "D", "E", and
"F" for the numbers 11 through 15, respectively. To program a 10, press
15, press
G 1
The displays will appear after a brief delay.
Use to toggle the cursor between the 4-digit address field and the data entry locations.
R
Enter the address directly using the number buttons.
The contents of the address will be read automatically, along with the feature name and programming information.
The cursor will advance to the data field. Enter the required data directly using the number buttons.
IMPORTANT:
EXIT DIRECT ADDRESS PROGRAM MODE: When done, press
X
GEM-P3200 Programming Instructions
.
B
to access Address 0900. The existing data will display and the cursor will ad-
through , respectively.
G 5
U D
Press or to save the contents of each address.
.
R
1 to enter a "1" in the display, and press
G 0
to exit and resume normal keypad operation.
C
L
WI818G 10/05
to exit and resume
C
. To program 11 through
NAPCO Security Systems