NAPCO GEMINI GEM-P3200 Programming Instructions Manual page 8

Page 8
Enable SIA CP-01?
Y/N
(Press YES or NO)
# Area 1 Keypads
Enter # KPs 01
(Direct Entry)
# Area 2 Keypads
Enter # KPs 00
(Direct Entry)
Central Phone #
(Direct Entry)
Easy Programming of Auto download ID #'s and PC Preset Callback Numbers (GEM-RP1CAe2 or GEM-K1CA
keypads only) from the Central Station Telephone number.
For unattended PC Preset downloading, it is now possible to set the Auto download ID #'s and PC Preset Callback
from the Keypad Easy Program Mode.
•
At the field for CENTRAL PHONE #, program an "F" followed by the Auto Download ID # (2 digits) and then the
Callback Telco # (up to 13 digits).
• D U
Press or to save.
•
Exit Program Mode (
•
Enter Master Code
•
Press or
A R
•
Go to Function "ACTIVATE DOWNLOAD Y/N" and press YES (
•
The panel will automatically call the PC Preset computer and download the program on the specified Auto
Download line # of PC Preset. Example: Program an Auto download ID # of 07 and a PC Preset Callback # of
1-516-842-9400
CENTRAL PHONE #
F 0 7 1 5 1 6 8 4 2 9 4 0 0
• Go to Central Phone # input screen and press: [*] [5] [0] [7] [1] [5] [1] [6] [8] [4] [2] [9] [4] [0] [0]
X
GEM-P3200 Programming Instructions
Enable SIA CP-01 Features?
•
Press the NEXT/YES button to enable.
•
Press the PRIOR/NO button to continue.
The SIA CP-01 Features are designed to reduce the incidence of false alarms. NOTE:
unless reporting, otherwise system trouble Fail to Communicate may occur.
Number of Keypads in Area 1
•
Enter the total number of Keypads to be installed in Area 1.
•
Valid entries are from 01 to 07. Directly enter the number of keypads, including leading zeros.
U
Press to save. Press the NEXT/YES button to proceed.
Number of Keypads in Area 2
•
Enter the total number of Keypads to be installed in Area 2.
•
Valid entries are from 00 to 07. Directly enter the number of keypads, including leading zeros.
U
Press to save. Press the NEXT/YES button to proceed. NOTE: Area 2 keypads must have zones in
Area 2, otherwise the keypad will indicate "Out Of System".
Central Station Receiver 1 Telephone Number
•
Enter telephone number of up to 16 digits.
•
Press through
1 9
•
Press through
G 1
•
Pre-Dial Delay = "D" ( G 4
• U
Press to save and press the NEXT/YES button to proceed.
NOTE: Central Station Receiver 2 and 3 Telephone Numbers must be entered in Direct Address Program-
ming. See CS Receiver Options.
)
CC
for digits 1–9; for a zero and
G 0
for letters B–F, respectively.
G 5
); Dial-Tone Detection = "E" (
or ).
E P
L
WI818G 10/05
Do not enable
•
for a blank ( ).
0
G 5 ).
D U
(or ).
NAPCO Security Systems