Programming Conventions Used In This Manual - NAPCO Gemini GEM-P816 Programming Instructions Manual

!
Page 14
PROGRAM THE DATA ENTRIES
1. Enter the panel's Dealer Security Code, then press
2. Answer NO to all questions until "ACTIVATE PROGRAM Y/N" is displayed; then press YES. NOTE: If you pass "ACTIVATE
PROGRAM", scroll backward using
3. Press to enter the Address Program Mode. Address "0000" will display.
C
4. Press
0716
vance to the data field.
5. Since you wish the timeout to be for 2 seconds (and 8 multiplied by ¼ second equals 2 seconds), press
. The numbers 08 will appear on the keypad display indicating the number of seconds entered.
08
U
6. Press to save. Address 0715 is now programmed with a 2-second chime.
7. Enter another 4-digit address to continue programming or press
eration.

PROGRAMMING CONVENTIONS USED IN THIS MANUAL

The Keypad Programming Worksheets in the back are provided as an address-programming reference to help the in-
staller modify his custom default program or to make minor field alterations to an existing panel program. It is recom-
mended that the panel be uploaded to NAPCO's PCD-Windows software following any keypad programming and that
the PCD-Windows's error-check feature be utilized to reduce the possibility of programming omissions or conflicts.
3
Keep the Keypad Programming Worksheets on file for future reference.
General Programming Steps
!
1. Contact the central station to ascertain receiver format, data format, event codes, subscriber numbers and tele-
phone number(s).
!
2. Select the desired features by circling
and Worksheets for guidance in selecting the "data" to be entered into those boxes.
!
3. Program the data entered in the boxes on the worksheets into the respective addresses. The display will show
the entry numerically, but if hexadecimal format will display "0" for the number 10, and letters "B", "C", "D", "E", and
"F" for the numbers 11 through 15, respectively. To program a 10, press
15, press
G 1
The displays will appear after a brief delay.
!
Use to toggle the cursor between the 4-digit address field and the data entry locations.
R
!
Enter the address directly using the number buttons.
!
The contents of the address will be read automatically, along with the feature name and programming information.
The cursor will advance to the data field. Enter the required data directly using the number buttons.
! IMPORTANT:
EXIT DIRECT ADDRESS PROGRAM MODE: When done, press
X
GEM-P816 Programming Instructions
.
B
to access Address 0716. The existing data will display and the cursor will ad-
#
the respective "address" boxes. Refer to the Programming Options
through , respectively.
G 5
U D
Press or to save the contents of each address.
.
R
to exit and resume normal keypad op-
C
G 0
to exit and resume normal keypad operation.
C
L
WI995C 2/04
. To program 11 through
NAPCO Security Systems