Conventions Used In This Manual - NAPCO LIBRA LIB-P432EX Programming Instructions Manual

The displays shown on the previous pages will appear after a brief delay.
Use to toggle the cursor between the 4-digit address field and the data entry locations.
w
Enter the address directly using the number buttons.
The contents of the address will be read automatically, along with the feature name and programming information.
The cursor will advance to the data field. Enter the required data directly using the number buttons.
u
Press to save the contents of each address.
EXIT DIRECT ADDRESS PROGRAM MODE: When done, press
operation.

CONVENTIONS USED IN THIS MANUAL

The Keypad Programming Worksheets in the back are provided as an address-programming reference to help the
installer modify his custom default program or to make
minor field alterations to an existing panel program. It is
recommended that the panel be uploaded to NAPCO's
PCD-Windows software
programming and that the PCD-Windows error-check
feature be utilized to reduce the possibility of
programming omissions or conflicts.
Note: Most of the addresses shown comprise two data
entry locations, left and right digits. Program the left
digits on the left data-display segment, and the right digit
on the right segment. For those addresses having only
one programmable nibble, program the right segment
only; the left segment should display a blank (•).
3
Keep the Keypad Programming Worksheets on file for
future reference.
General Programming Steps
1. Contact the central station to ascertain receiver
format, data format, event codes, subscriber
numbers and telephone number(s).
2. Select the desired features by circling
respective "address" boxes.
Programming Options
guidance in selecting the "data" (1,2,4,8) to be
entered into those boxes.
3. Program the data entered in the boxes on the
worksheets into the respective addresses. The
display will show the entry numerically, but will
display "0" for the number 10, and letters "B", "C",
"D", "E", and "F" for the numbers 11 through 15,
respectively. To program a 10, press
. To program 11 through 15, press
0
through
1 G5
NOTE: See the Direct Address Programming Example on the previous page.
NAPCO Security Systems
following any keypad
the
Refer to the
and Worksheets for
G
G
, respectively.
RESET (
y
DATA ENTRY SELECTIONS
(BINARY VALUE CIRCLED)
8 4 2 1
8 4 2
8 4 1
8 4
8 2 1
8 2
8 1
8
4 2 1
4 2
4 1
4
2 1
2
1
Table 1 (above). Determining data entry for a location (each
"nibble"). Numbers in parentheses indicate data for selected
zones or features. (See Programming Worksheets that
follow).
LIBRA LIB-P432EX Series Programming Instructions
) to exit and resume normal keypad
PRESS
ENTRY
N
TOTAL
0
blank
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
G 0
10
G 1
11
G 2
12
G 3
13
G 4
14
G 5
15
Page 23
KEYPAD
DISPLAYS
•
1
2
3
4
5
6
7
8
9
0
B
C
D
E
F