4-1-1] Wired Extension-Extension Settings-Clip Generate - Panasonic KX-TDA50 Pc Programming Manual

2.11.2 [4-1-1] Wired Extension—Extension Settings—CLIP
Generate
CLIP Generate allows the CLIP numbers for a set of locations in series to be programmed together.
Pre-assigned CLIP numbers for those locations will be overwritten.
If a number generated here is longer than 16 digits, the additional digits will be discarded.
Location Entry—Beginning Entry Location (Ext. Number)
Specifies the extension number of the first location to be programmed.
Default
Extension number of port 01 of the first extension card that is installed.
Value Range
Wired extension number
Maintenance Console Location
2.11.2 [4-1-1] Wired Extension—Extension Settings—CLIP Generate
Programming Manual References
2.11.1 [4-1-1] Wired Extension—Extension Settings
Feature Manual References
1.3.13 CLIP (Calling Line Identification Presentation)
Location Entry—Number to Generate
Specifies the number of locations to be programmed.
A CLIP number will only be assigned to connected wired extensions, even if the number entered here
is larger than the total number of wired extensions.
Default
Depends on installed cards
Value Range
1–total number of connected wired extensions
Maintenance Console Location
2.11.2 [4-1-1] Wired Extension—Extension Settings—CLIP Generate
Programming Manual References
2.11.1 [4-1-1] Wired Extension—Extension Settings
Feature Manual References
1.3.13 CLIP (Calling Line Identification Presentation)
2.11 [4] Extension
PC Programming Manual 467