Utility-File Transfer Pc To Pbx (Sd Card) - Panasonic KX-TDA50 Pc Programming Manual

2.6 Utility
• The version of the PRI23 card must be 2.000 or later.
To perform a network loopback test
1.
From the Utility menu, select Diagnosis.
2.
Click on the Status cell of the PRI23 card, and set it to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
4.
Select the Loopback Type option.
A new window will be displayed.
5.
Select Point1 or Point2 depending on the type of loopback test you want to perform.
The available selections may vary depending on the hardware version of the card.
6.
Click Apply.
Preparation for the test is complete. The test will start automatically.
7.
After the test is complete, select Release and click Apply.
8.
Click Close to return to the Diagnosis screen.
2.6.2 Utility—File Transfer PC to PBX (SD Card)
Copies PBX system files (program files and data files) from the connected PC to the SD memory card
installed in the PBX. Pre-existing files on the SD memory card are overwritten.
This option is only available at Installer level.
Two types of files can be copied using this tool:
• Program files: These contain the programs used to operate cards within the PBX and CSs,
acting as on-board drivers.
• Data files: These contain the initial configuration data for individual cards and settings.
Not all files that are copied using this tool are automatically made active. To install new program files
or main system data to the PBX, use the System Reset—Reset by the Command utility (see 2.6.17
Utility—System Reset—Reset by the Command) for PMPR/PSMPR/PLMPR and DSYS/DSSYS/
DLSYS files, and the SD Card File View and Load utility (see 2.6.4 Utility—SD Card File View and
Load) for all other files.
The PBX examines the header information of a file to determine 2 things: whether the file contains
supported data, and which system component the file applies to.
Only files whose header information matches that of a system file supported by the PBX can be
transferred. Attempting to transfer any other type of file results in an error message.
The names of all files that can be stored on the SD memory card are as follows:
Main Program
KX-TDA50
Name on SD Memory Card
PSMPR
PSMPR_S
48 PC Programming Manual
Corresponding Card
MPR
MPR*