Panasonic KX-TDA50 Pc Programming Manual page 96

2.8 [1] Configuration
Parallel Telephone Ringing
Specifies whether the sub telephone (SLT) rings at the same time as the main telephone (DPT) for
an incoming call. This setting is only available when Port Type on this screen is set to S-Hybrid.
Default
Yes
Value Range
Yes, No
Maintenance Console Location
2.8.5 [1-1] Slot—Port Property - Extension Port
Programming Manual References
None
Feature Manual References
1.13.2 Paralleled Telephone
DPT Type—Type
Selects the port type.
To change the port type of an extension port, follow the steps below:
1.
Set the status of the extension port to "OUS".
2.
Change the port type of the extension port, then click Apply.
3.
Set the status of the extension port to "INS".
When changing the port type of an extension port for which Wireless XDP has been set on the
2.11.1 [4-1-1] Wired Extension—Extension Settings screen, the Wireless XDP setting must
be deleted first.
When changing the type of a port for which one or more SDN buttons are set (except when
changing between PC Console and Telephone), all SDN buttons customized for that device will
be deleted. When you attempt to apply the new settings, a warning message is displayed
showing the slot and port number for which SDN buttons will be deleted. If you do not wish to
delete SDN buttons for this port, click Cancel.
Default
Normal
Value Range
Normal: For connecting a DPT
DSS: For connecting a DSS Console (A maximum of 4 [with the KX-TDA50], 8 [with the KX-TDA100/
KX-TDA200] or 64 [with the KX-TDA600] DSS Consoles can be connected to the PBX.)
VM (DPT): For connecting a Panasonic VPS through DPT Integration
PC Console: For connecting a PC Console (A maximum of 2 [with the KX-TDA50] or 8 [with the KX-
TDA100/KX-TDA200/KX-TDA600] PC Consoles can be connected to the PBX.)
Maintenance Console Location
2.8.5 [1-1] Slot—Port Property - Extension Port
96 PC Programming Manual