Bank Angle Sensor - KYMCO XCITING 500 Service Manual

20
. LIGHTS/METERS/SWITCHES

BANK ANGLE SENSOR

INSPECTION
Support the scooter level surface.
Remove the meter panel (page 2-13).
Turn the ignition switch to "ON" and measure
the voltage between the following terminals of
the bank angle sensor connector with the
connector connected.
TERMINAL
Black/Blue Battery voltage
Black/White Battery voltage – (0-1 V)
The engine should stop as you incline the bank
angle sensor approximately degrees to the left or
right.
REMOVAL/INSTALLATION
Disconnect the bank angle sensor connector.
Remove the two screws, washers and bank angle
sensor.
20-17
STANDARD
Bank Angle Sensor
Bank Angle Sensor Screws/Washers
XCITING 500