14.STEERING HANDLEBAR/FRONT WHEEL/
FRONT SHOCK ABSORBER
Remove the dust seals
Install the bearing remover into the bearing.
Drive the bearing out of the wheel hub.
Remove the distance collar and drive out the
other bearing.
Special tool: Bearing remover
NOTE:
Replace the wheel bearings in pairs.
Do not reuse old bearings.
ASSEMBLY
Pack a new bearing cavities with grease.
Drive the new left bearing squarely with the
sealed side facing up until it is fully seated.
Special tool:
Oil seal & bearing install driver
14-7
E037
E014
XCITING 500
Dust Seals