KYMCO XCITING 500 Service Manual page 187

10. DRIVE AND DRIVEN PULLEY
Clean any oil and grease from the pulley
faces and the drive belt.
Install the movable drive face assembly onto
the crankshaft while holding the ramp plate.
Install the washer.
Install the drive belt and clutch/driven pulley
assembly.
＊
Install the drive belt with the arrow mark
facing up and towards to clockwise.
Hold the clutch outer with the special tool as
shown.
Special tool:
Universal holder
Install the collar and nut.
Tighten the nut to the specified torque.
Torque: 80 N•m (8 kgf•m, 58 lbf•ft)
10-11
Movable Drive Face Assembly
Drive Belt
Clutch Outer
E017
XCITING 500
Washer
Clutch/Driven Pulley Assembly
Collar/Nut
Universal Holder