KYMCO XCITING 500 Service Manual page 341

20
. LIGHTS/METERS/SWITCHES XCITING 500
Dust Cover
If the indicator does not come on, inspect as
follow:
Remove the dust cover and disconnect oil
pressure switch terminal.
Oil Pressure Switch Terminal
Short the oil pressure switch wire terminal with
the ground using a jumper wire.
The oil pressure warning indicator comes on
with the ignition switch is ON.
If the light does not comes on, check the fuse
and wires for a loose connection or an open
circuit.
Start the engine and make sure that the light
goes out.
If the light does not go out, check the internal oil
for leak.
If the engine oil does not leak, replace the oil
pressure switch (see below).
Oil Pressure Switch
REMOVAL/INSTALLATION
Remove the dust cover and disconnect oil
pressure switch terminal.
Remove the oil pressure switch from the
crankcase.
20-11