KYMCO XCITING 500 Service Manual page 195

10. DRIVE AND DRIVEN PULLEY
Install the movable driven face onto the
driven face.
Install the guide rollers and guide roller pins.
Filling 8 g of grease to each guide groove.
Install the seal collar.
Install spring collar.
Install washer.
Install driven face spring.
Install the drive belt into the driven pulley.
Squeeze and hold the drive belt your hand.
Set the clutch spring compressor over the
clutch/driven pulley assembly and hold the
spring compressor in a vice.
Special tool:
Clutch Spring Compressor
Compress the driven face spring.
Install and tighten the clutch drive plate nut
to the specified torque.
Torque: 78 N•m (7.8 kgf•m, 56 lbf•ft)
10-19
E053
XCITING 500
Grease
Driven Face Spring
Washer
Lock Nut Wrench
Clutch spring compressor