KYMCO XCITING 500 Service Manual page 276

16
. BRAKE SYSTEM
Remove the master cylinder reservoir cap and
diaphragm.
Suck up the old brake fluid as much as
possible.
Fill the reservoir with new brake fluid.
Specification and classification: DOT 4
Step 1:
Connect a clear hose to the delay valve air
bleed screw and insert the other end of the
hose into a receptacle.
Loosen the air bleed screw and pump the
brake lever until the old brake fluid is
completely out of the brake system. Close
the air bleed screw and disconnect the clear
hose. Fill the reservoir with new brake fluid
to the upper end of the inspection window.
Step 2:
Connect a clear hose to the right front
caliper air bleed screw. The right brake fluid
replacement is the same way as that of the
step 1.
Screws
Relay Valve Air Bleed Screw
Right Front Caliper Air Bleed Screw
XCITING 500
Cap/Diaphragm
Clear Hose
Clear Hose
16-6