10. DRIVE AND DRIVEN PULLEY
Remove the guide roller pins, guide rollers
and the movable driven face.
Remove the O-rings and oil seals from the
movable driven face.
Driven Face Bearing Replacement
Remove the driven face needle bearing.
Remove the snap ring, then remove the ball
bearing.
Apply grease to new ball bearing.
Install the ball bearing into the driven face.
Install the snap ring to groove in the driven
face securely.
10-15
Movable Driven Face
Guide Roller Pins/Guide Rollers
Oil Seals
O-rings
Snap Ring
Ball Bearing
XCITING 500
Needle Bearing