Setting the DCS CODE
1. Touch [F MW] [SQTYP].
If [SQTYP] is not displayed, touch [FWD →] to display [SQTYP] and then touch it.
2. Rotate the DIAL knob to select "DCS".
3. Press the PTT switch to save the setting and return to normal operation.
4. Touch [F MW] [CODE].
5. Rotate the DIAL knob to select the DCS code.
6. Press the [BACK] key to save the detected tone
frequency and return to normal operation.
• The DCS code set by the above operation is the common setting for all transmissions with
a DCS Code (DCS, D CODE, T DCS, D TONE).
• The default DCS code is "023".
Searching for the DCS Code Used by the Other Station
Search for the DCS code used by the other station.
1. Touch [F MW] [SQTYP].
If [SQTYP] is not displayed, touch [FWD →] to display [SQTYP] and then touch it.
2. Rotate the DIAL knob to select "DCS".
3. Press the PTT switch to save the setting and return to normal operation.
4. Touch [F MW] [CODE].
The DCS code setting screen is displayed.
5. Touch [SEARCH].
• The transceiver starts to search for the DCS code.
• When a corresponding DCS code is detected, a
beep sound is emitted. The detected DCS code
blinks. The searching stops for 5 seconds and the
audio is heard.
6. Touch [STOP] to stop searching.
7. Press the [BACK] key to save the detected DCS code and return to normal
operation.
To set the transceiver operation when scanning stops, press and hold the [DISP] key
[SCAN] [4 SCAN RESUME]. This setting is common for all scan settings, the tone search
function and DCS search function.
9
2 DCS CODE
DCS
:
023
2 DCS CODE
DCS
:
023