Rear Wheel Related Parts Inspection - Suzuki 2005 GSF1200 Service Manual

2D-12 Wheels and Tires:

Rear Wheel Related Parts Inspection

Refer to "Rear Wheel Assembly Removal and
Installation: ".
Tire
Refer to "Tire Inspection: in Section 0B".
Rear Brake Disc
Refer to "Rear Brake Disc Inspection: in Section 4C".
Wheel Damper
Refer to "Drive Chain Related Parts Inspection: in
Section 3A".
Sprocket
Refer to "Drive Chain Related Parts Inspection: in
Section 3A".
Dust Seal
Inspect the dust seal lip for wear or damage. If any
defects is found, replace the dust seal with a new one.
Refer to "Rear Wheel Dust Seal / Bearing / Removal and
Installation: ".
Axle Shaft
B649G12406021
Using a dial gauge, check the rear axle for runout, If the
runout exceeds the limit, replace the axle shaft.
Axle shaft runout
Service limit: 0.25 mm (0.010 in)
Special tool
(A): 09900–20607 (Dial gauge (1/100mm,
10mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100mm))
Wheel
Make sure that the wheel runout checked as shown
does not exceed the service limit. An excessive runout is
usually due to worn or loosened wheel bearings and can
be reduced by replacing the bearings. If bearing
replacement fails to reduce the runout, replace the
wheel.
Wheel runout
Service limit (Axial and Radial): 2.0 mm (0.08 in)
I649G1240029-01
Wheel clean and check. Refer to "Wheel / Tire / Air Valve
Inspection and Cleaning: ".
(A)
(B)
(C)
I649G1230034-02
I649G1240014-01