Oil Cooler / Oil Cooler Hose Removal And Installation - Suzuki 2005 GSF1200 Service Manual

Oil Cooler / Oil Cooler Hose Removal and
Installation
Removal
1) Drain engine oil. Refer to "Engine Oil and Filter
Replacement: in Section 0B".
2) Remove the oil cooler hose union bolts (1) and
gasket washers.
1
3) Remove the oil cooler hose bracket bolts, left and
right.
4) Remove the oil cooler assembly by removing its
mounting bolts.
5) Remove the oil cooler hoses (2) and O-rings from
the oil cooler.
B649G11606030
Installation
Installation is in the reverse order of removal.
Pay attention to the following points:
CAUTION
!
Replace the O-rings and gasket washers with
I649G1160019-01
new ones to prevent oil leakage.
• Tighten the oil cooler hose connecting bolts to the
specified torque.
Tightening torque
Oil cooler hose connecting bolt (a): 10 N·m (1.0
kgf-m, 7.0 lb-ft)
I649G1160020-01
• Tighten the oil cooler mounting bolts to the specified
torque.
Tightening torque
Oil cooler mounting bolt (b): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
I649G1160021-01
Engine Cooling System:
2
(a)
(b)
1F-8
I649G1160022-01
I649G1160023-02
I649G1160024-01