Suzuki 2005 GSF1200 Service Manual page 36

0B-10 Maintenance and Lubrication:
3) Apply engine oil lightly to the O-ring of new oil filter,
before installation.
CAUTION
!
ONLY USE A GENUINE SUZUKI
MOTORCYCLE OIL FILTER.
Other manufacturer's oil filters may differ in
thread specifications (thread diameter and
pitch), filtering performance and durability
which may lead to engine damage or oil
leaks. Also, do not use a genuine Suzuki
automobile oil filter on this motorcycle.
4) Install a new oil filter. Turn it by hand until you feel
that the oil filter O-ring contacts the oil filter mounting
surface. Then, tighten the oil filter two full turns (or to
specified torque) using the special tool.
NOTE
To properly tighten the oil filter, use the
special tool. Never tighten the oil filter by
hand only.
Special tool
(A): 09915–40610 (Oil filter wrench)
Tightening torque
Oil filter (a): 20 N·m (2.0 kgf-m, 14.5 lb-ft)
1,
(a)
5) Add new engine oil and check the oil level is as
described in the engine oil replacement procedure.
Necessary amount of engine oil
Oil change: 3.3 L (3.4/2.9 US/lmp qt)
Oil and filter change: 3.5 L (3.6/3.0 US/lmp qt)
Engine overhaul: 4.6 L (4.9 /4.0 US/lmp qt)
(A)
I649G1020024-03
Throttle Cable Play Inspection and Adjustment
Inspect throttle cable play
Initially at 1 000 km (6 000 miles, 2 month) and every
6 000 km (4 000 miles, 12 months) thereafter.
Inspect and adjust the throttle cable play "a" as follows.
Throttle cable play "a"
2.0 – 4.0 mm (0.08 – 0.16 in)
1) Loosen the lock-nut (1) of the throttle pulling cable
(2).
2) Turn the adjuster (3) in or out until the throttle cable
play "a" (at the throttle grip) is between 2 – 4 mm
(0.08 – 0.16 in).
3) Tighten the lock-nut (1) while holding the adjuster
(3).
1
2
WARNING
!
After the adjustment is completed, check that
handlebar movement does not raise the
engine idle speed and that the throttle grip
returns smoothly and automatically.
B649G10206012
"a"
I649G1020026-01
3
I649G1020027-01