Suzuki 2005 GSF1200 Service Manual page 379

7) Insert the clutch drive plates and driven plates one by one into the clutch sleeve hub in the prescribed order, No.3
drive plate (6) first.
8
"B"
6. No.3 drive plate
7. No.1 drive plate
8. No.2 drive plate
9. No.1 driven plate (5 – 8 pcs)
: The No.1 and No.2 driven plats are 9 in total.
NOTE
For drive plate
Three kinds of the drive plate (No. 1, No. 2 and No. 3) are equipped in the clutch system, they can be
distinguished by the inside diameter and clutch facing "C".
Drive plate
No.1
No.2
No.3
NOTE
For driven plate
Two kinds of the driven plate (No. 1 and No. 2) are equipped in the clutch system, they can be
distinguished by the thickness. The No. 1 and No. 2 driven plates are 9 in total. The driven plate No. 2
should be used within 4 pcs. The driven plate No. 2 should be installed between third to seventh
position from the pressure plate.
"C": Clutch facing
: No.1 and No.2 drive plates resemble each other very closely in external appearance.
Make sure to check the numbers of clutch facing, before installing them.
101 mm (4.0 in)
101 mm (4.0 in)
108 mm (4.3 in)
10
10. No.2 driven plate (1 – 4 pcs)
: The No.1 and No.2 driven plats are 9 in total.
"A": Direction of inside
"B": Pressure plate side
"C"
I649G1530045-01
I.D.
Clutch:
7 6
"A"
9
I649G1530044-02
Clutch facing "C"
40 pcs
48 pcs
48 pcs
5C-17