Suzuki 2005 GSF1200 Service Manual page 126

1D-58 Engine Mechanical:
Oil Pump Driven Gear
• Install the washer (1), pin (2), oil pump driven gear (3)
and washer (4).
1
2
Gearshift
• Install each pawl (1) into the gearshift cam driven gear
(2).
• The large shoulder "a" must face to the outside.
• Install the cam guide (3) and pawl lifter (4).
• Apply a small quantity of THREAD LOCK "1342" to
the screws.
: Thread lock cement 99000–32050 (Thread
Lock Cement 1342 or equivalent)
"a"
• Install the gearshift shaft (5).
NOTE
Align the center teeth on the gearshift shaft
with the center teeth on the gearshift cam
driven gear.
5
3
4
I649G1140178-01
1
3
4
1
2
I649G1140352-01
I649G1140176-01
• Install the washer and fix the gearshift shaft with the
snap ring.
CAUTION
!
Replace the snap ring with a new one.
Special tool
: 09900–06107 (Snap ring pliers)
Clutch
• Install the clutch component parts. Refer to "Clutch
Installation: in Section 5C".
CKP Sensor / Oil Pressure Switch
• Install the CKP sensor component parts. Refer
to"CKP Sensor Removal and Installation: in Section
1H".
• Install the oil pressure switch and connect the oil
pressure switch lead wire. Refer to "Oil Pressure
Switch Removal and Installation: in Section 1E".
• Pass the CKP sensor lead wire through the upper
crankcase as shown.
I649G1140177-01
I649G1140195-01