• Apply a small quantity of THREAD LOCK "1342" to the two screws.
: Thread lock cement 99000–32050 (Thread Lock Cement 1342 or equivalent)
• Install the countershaft bearing retainer (12).
Gear Position Switch
• Install the gear position switch.
NOTE
When installing the gear position switch, be
sure to install the spring (1), switch contact
(2) and O-ring (3) properly.
CAUTION
!
Replace the O-ring with a new one.
3
1
2
I649G1140169-01
12
I649G1140168-02
• Install the oil seal retainer (4) with the four bolts and
then bend up the tabs on the retainer.
NOTE
Route the gear position switch lead wire to
the inside of the oil seal retainer's tab "A" as
shown.
4
"A"
Starter Clutch
• Install the starter clutch component parts. Refer to
"Starter Clutch Removal and Installation: in Section
1I".
Engine Mechanical:
1D-57
I649G1140170-01