Centering The Input Guide Under The Material; Setting The Feed Angle - Pitney Bowes AddressRight DA Series Operator's Manual

2 • Printer Basics

2. Centering the Input Guide Under the Material

A. Loosen the input guide angle adjustment knob.
B. Place a sample piece of material in the feed area, up against
the rear wall. Center the input guide under your sample piece of
material.
C. Tighten the knob to lock the guide in place.

3. Setting the Feed Angle

The feed angle of the input guide stacker depends on the material
you're running:
• Light material, flexible material or empty envelopes:
adjust to a high angle, approximately 45 degrees.
• Heavy material, stiff material or filled envelopes:
adjust to a low angle, approximately 30 degrees.
To make the adjustment:
A. Make sure the input guide angle
adjustment knob is loosened.
B. Move the input guide up or
down as required.
C. Tighten the knob to secure the
2-6
45°
30°
SV61722 Rev. D