Ricoh C249 Service Manual page 253

Rev. 10/2006
[M]
[G]
[N]
3. Connect CN101 [G] on the interface board to CN117 [H] on the MPU (
4. Clamp the interface cable [I] at the positions shown.
5. Connect the short end of the interface cable [J] (4-pin connector) to the main
harness [K] (narrow 4-pin connector).
6. Clamp the main harness [L] (wide 4-pin connector) at the position shown.
NOTE: This is because the wide 4-pin connector of the main harness is not
used.
7. Connect the long end of the interface cable [M] (black connector) to CN102 [N]
on the interface board.
SM
INSTALLATION PROCEDURE
[I]
[H]
[L]
[K]
[J]
C264I001.WMF
1-27
x 2).
C264