Main Menu No.3: System Settings - Ricoh C249 Service Manual

Rev. 07/2006
⇒
5.3.12 SP2-95: PAPER TABLE STANDBY POSITION
With this SP mode, the paper tray standby position can be changed to a higher
position. As a result, the First Print time for the next job will be about 3 seconds
faster.
This SP mode sets whether the paper feed table will return to the lower standby
position (standard) or the upper standby position.
ON:
OFF (default):
NOTE: In the following cases, the paper feed table return to the lower (standard)
standby position even if SP2-95 is ON. This is to make sure that the
master making unit does not touch the paper feed table:
When the Master End condition occurs.
•
When a B-jam (Master Eject Jam) or a D-jam (Master Feed Jam)
•
occurs.
When the paper height sensor is activated at main power ON.
•

5.4 MAIN MENU NO.3: SYSTEM SETTINGS

5.4.1 SP TABLE
No. Menu Items
3-1 Input the present time
3-2 Input Tel number
3-3 Input serial number
3-4 Input installation data
3-10 Key counter setting
5.4.2 SP3-1: INPUT THE PRESENT TIME
Input the year, the month / date, and the time in that order. Press the Enter key
between each one.
Input the last two digits of the present year (two-digit number).
↓#
Input the present month (two-digit number).
↓#
Input the present date (two-digit number).
↓#
SM
The paper feed table returns to the upper standby position
after printing or master-making.
The paper feed table returns to the lower (standard) standby
position after printing or master-making.
Default
-
-
-
-
No
5-7
MAIN MENU NO.3: SYSTEM SETTINGS
Settings
5.4.2
5.4.3
No/Yes
C249