Sp8-2: Upload Main Firmware - Ricoh C249 Service Manual

5.9.3 SP8-2: UPLOAD MAIN FIRMWARE

Writes firmware to a flash memory card (P/N' #A2309352) from the machine.
1. Refer to steps 3 to 5 of section 5.9.2.
2. Connect the power cord, then turn on the main switch while holding the Clear
modes key.
3. Access SP8-2 and press the OK key. Press the "Enter(#)" key.
4. Refer to steps 8 and 10 in section 5.9.2.
5.9.4 SP8-10: TEST PATTERNS
Makes prints without using the scanner.
Access SP8-10 and select the number "6", then press the "Enter(#)" key.
Other numbers are as shown below, but do not use them except the number "6".
1: Grid, 2: Vertical, 3: Horizontal gray, 4: Vertical gray, 5: 16 grays,
6: Cross, 7: Diagonal grid, 8: 256 grays, 9: 64 grays
5.9.5 SP8-21: PAPER FEED TEST (15 RPM)
Feeds paper at the lowest speed (15 rpm).
1. Set a stack of paper on the paper feed table.
2. Access SP8-21 and press the OK key.
3. Exit the SP mode and enter the number of sheets that you want to feed.
4. Press the Print key.
5. To exit this mode, turn off the main switch.
5.9.6 SP8-22: FREE RUN PAPER FEED (15 RPM)
Drives the paper feed mechanism at the lowest speed (15 rpm) without paper.
1. Access SP8-22 and press the OK key.
2. Exit the SP mode and enter the number of times that you want to repeat the
paper feed cycle.
3. Press the Print key.
4. To exit this mode, turn off the main switch.
SM
MAIN MENU NO.8: SYSTEM TEST
5-27 C249