Sp2-7: Chinese Display Setting (China Model Only) - Ricoh C249 Service Manual

5.3.2 SP2-7: CHINESE DISPLAY SETTING (CHINA MODEL ONLY)

To change the warning message when you made a mistake of installing different
masters in the machine depends on the selling company.
0: Ricoh master type
1: Gestetner master type
5.3.3 SP2-32: INK SUPPLY AFTER TRIAL9
Ink is detected and supplied after the trial print when this SP is on.
5.3.4 SP2-33: RE - FEEDING SETTING
When the machine performs re-feeding, the paper registration position can be up to
5mm out of range. If this incorrect position is not acceptable to the customer,
change this SP mode to "OFF".
ON: Re- feeding is on (factory setting).
OFF: Re- feeding is off.
5.3.5 SP2-34: SLOW STARTING MODE
Increase the image density of trial prints.
The figures below are drum-rotating speeds. A setting of "30rpm" will increase the
image density of trial prints.
This mode was added because trail print images are lighter than with other models.
Trial
Setting
Print
30rpm 30rpm
45rpm 45rpm
5.3.6 SP2-35: PRINTING PRESSURE ADJUSTMENT
Changes the printing pressure of all printing speed (60 to 120 rpm).
NOTE: 1) Adjust this SP mode after adjusting the printing pressure. (! 3.8.3)
2) When adjust printing pressure of each printing speed or temperature,
use SP6-70 to 87.
SM
1st 2nd
Print Print
45rpm 60rpm
60rpm 75rpm
5-5
MAIN MENU NO.2: BASIC SETTINGS
3rd 4th
Print Print
75rpm 90rpm 105rpm
90rpm 105rpm 120rpm
5th 6th
Print Print
120rpm
120rpm
C249