Floppy Disk Drive Replacement - DEC DECstation 316+ Service Manual

3–10 FRU Replacement

3.2.5 Floppy Disk Drive Replacement

Replace the floppy disk drive as follows (Figure 3–4):
1. Remove the system cover (Section 3.2.4).
2. Remove the actuator arm (Figure 3–12).
3. Remove the ribbon cable from the back of the drive.
4. Remove the three mounting screws that hold the drive in place
and remove the drive.
5. Set the switch on the replacement drive to match that of the
removed drive.
6. Install the replacement drive using the three mounting screws.
7. Reconnect the ribbon cable to the floppy drive and the
power switch extender to the switch on the power supply
(Figure 3–12).
8. After replacing the drive reconnect all system cables.
9. Verify the operation of the replaced drive.
10. Reinstall the system cover.