Toyota 1KZ-TE Repair Manual page 316

CLICK HERE TO VIEW CHAPTER INDEX
Indentation
Long
(1)
(3)
(2)
Short
Short
STARTING
(b)
If the depth of wear is greater than the maximum, replace the
contact plate.
Wear
S04199
(c)
SST
S04200
(d)
Protrusion
(5)
(6)
(4)
(7)
Inside
HINT:
Match the protrusion of the insulator with the indentation of the
B09802
housing.
NOTICE:
Be careful to install the terminal insulators (inside) and
wave washer and terminal bolt in the correct direction.
- - STARTER
Inspect the contact plate for wear.
Using vernier calipers, measure the contact plate for
depth of wear.
Maximum wear: 0.9 mm (0.035 in.)
Remove the terminal kit parts.
(1) Using SST, loosen the terminal nuts.
SST 09810 -- 38140
(2) Terminal C:
Remove the terminal nut, wave washer, terminal in-
sulator (outside), O--ring, terminal bolt, contact
plate and terminal insulator (inside).
(3) Terminal 30:
Remove the terminal nut, wave washer, terminal in-
sulator (outside), packing, O--ring, terminal bolt,
contact plate, terminal insulator (inside).
Install new terminal 30 kit parts.
(1) Temporarily install a new terminal insulator (inside).
(2) Temporarily install a new contact plate.
(3) Temporarily install a new terminal bolt.
(4) Temporarily install a new O--ring.
(5) Temporarily install a new packing and new terminal
insulator (outside).
(6) Temporarily install a new wave washer.
(7) Temporarily install a new terminal nut.
1KZ-TE Pages From Manual
TO MODEL INDEX
ST- -13
CONTINUED