Toyota 1KZ-TE Repair Manual page 288

CLICK HERE TO VIEW CHAPTER INDEX
LU- -14
Adhesive
Seal Packing
A
A
LUBRICATION
(b)
P13085
(c)
(d)
P13102
3 .
Install a new gasket and the oil strainer with the 2 bolts and 2
nuts.
4.
(a)
B09513
NOTICE:
Do not use a solvent which will affect the painted surfaces.
(b)
B
B
P13114
- - OIL PUMP
Pour in approx. 20 cc (0.12 cu in.) of engine oil into the oil
pump.
Apply adhesive to 2 or 3 threads of the taper screw.
Adhesive:
Part No. 08833- -00080, THREE BOND 1344,
LOCTITE 242 or equivalent.
Install the taper screw plug.
I NS TALL O I L S T RAI NE R
Torque: 8 N∙m (80 kgf∙cm, 69 in.∙lbf)
INSTALL OIL PAN
Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the oil pan
and cylinder block.
Using a razor blade and gasket scraper, remove all
S
the old packing (FIPG) material from the gasket sur-
faces and sealing groove.
Thoroughly clean all components to remove all the
S
loose material.
Using a non--residue solvent, clean both sealing
S
surfaces.
Apply seal packing to the oil pan as shown in the illustra-
tion.
Seal packing: Part No. 08826 - -00080 or equivalent
Install a nozzle that has been cut to a 3 -- 5 mm (0.12
S
-- 0.20 in.) opening.
Parts must be assembled within 5 minutes of ap-
S
plication. Otherwise the material must be removed
and reapplied.
Immediately remove nozzle from the tube and rein-
S
stall cap.
1KZ-TE Pages From Manual
TO MODEL INDEX
CONTINUED