Toyota 1KZ-TE Repair Manual page 188

CLICK HERE TO VIEW CHAPTER INDEX
Cut Position
ENGINE MECHANICAL
(g) Check the piston pin fit at normal room temperature. Coat
Piston
the piston pin with engine oil, and push it into the connect-
Pin
ing rod with your thumb.
3 . G RI ND AND HO NE MAI N J O URNALS AND/ O R CRANK
PINS
Grind and hone the main journals and/or crank pins to the fin-
ished undersized diameter
Install new main journal and/or crankshaft pin undersized bear-
ings.
EM8198
4 . RE P L ACE CRANKS HAFT RE AR O I L S E AL
HINT:
There are 2 methods (A and B) to replace the oil seal which are
as follows.
(a) If the rear oil seal retainer is removed from the cylinder
block:
(1)
P12866
(2)
SST
(3)
SST
P12867
(b) If the rear oil seal retainer is installed to the cylinder block:
(1)
(2)
NOTICE:
Be careful not to damage the crankshaft. Tape the screw-
driver tip.
P12630
(3)
(4)
SST
SST
P12629
- - CYLINDER BLOCK
(See page EM -- 83).
Using a screwdriver and hammer, tap out the oil
seal.
Using SST and a hammer, tap in a new oil seal until
its surface is flush with the rear oil seal retainer
edge.
09223 -- 15030, 09252 -- 10010
Apply MP grease to the oil seal lip.
Using a knife, cut off the oil seal lip.
Using a screwdriver, pry out the oil seal.
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its
surface is flush with the rear oil seal retainer edge.
09223 -- 15030, 09252 -- 10010
1KZ-TE Pages From Manual
TO MODEL INDEX
EM- -93